DIY Paracord Lanyard For Vapor Pen | Paracord Projects

Vapor Pens are all the rage these days, but they can be awfully expensive. If you’re prone to being forgetful or clumsy, this Vapor Pen lanyard will keep your loving chemical brother safe and snug around your neck. Even better, you won’t have to dig through your pocket every time you want to use it.

How to Make a Paracord Lanyard For Your Vapor Pen

Supplies for your Vapor Pen Paracord Lanyard project:

• (1) 5-ft strand of paracord
• (1) 4-ft strand of paracord
• (1) Scissors
• (1) Lighter
• (Optional) Piece of wood with a nail in it or any similar surface to help you create your lanyard from a fixed point

Step 1: Take the 5-ft strand and fold it in half

Step 2: Make a loop with the two ends

Step 3: Thread the ends through the loop

Step 4: Pull tight to create a knot

Step 5: Hook the midsection of your 5-ft paracord over a nail

Note: This step is optional. You can also tape the midsection to a table, have a friend hold it, or plain old-school-it by just letting it sit there. The nail makes the braiding process easier, but it’s not necessary.

Step 6: Fold the 5-ft paracord in half

Step 7: Begin the braid with the 4-ft paracord behind the 5-ft paracord

Step 8: Take the left side of the 4-ft paracord and cross it over both strands of the 5-ft paracord and its other side

Step 9: With the same paracord, cross it back under itself and under the two strands of the 5-ft paracord

Step 10: Still continuing with the same paracord, take the right side and cross it under the two strands of the 5-ft paracord

Step 11: Cross it under itself

Step 12: Thread the end through the uppermost loop as shown

Step 13: Pull tight

Step 14: Take the left strand of the 4-ft paracord and cross it over both strands of the 5-ft paracord and itself

Step 15: Wrap it behind itself and the two strands of the 5-ft paracord

Step 16: Take the right strand of the 4-ft paracord and wrap it behind the two strands of the 5-ft paracord

Step 17: Cross it behind itself

Step 18: Thread it through the uppermost loop

Step 19: Pull tight

Step 20: Repeat steps 14 through 19

Each knot is tied exactly the same. Continue tying knots until you’ve reached your desired length. We made 7 knots in ours.

Step 21: Cut the excess string off your knot

Step 22: Use a lighter to melt the frays of the paracord

Step 23: Cut the excess string off the knotted end of the 5-ft paracord

Step 24: Melt the frays with a lighter

Step 25: Take your Vapor pen and place it into the loop of the lanyard

Step 26: Pull the loop tight by sliding the snake knot toward the Vapor Pen

Now that you have your Vapor Pen attached to your neck, you can puff on that bad boy all you want without having to dig through your pockets or worry about losing it.

You can also use this paracord lanyard for holding other things! Like your keys. Or a hammer. Or your wife’s purse.

…or your dignity.

Like this Post?

Check out:

Badass Paracord Solid Gear Wrap